1.update CPU uCode to support E version CPU2.add IPMI function3.add AIC8140 RAID function Specifications:Processor Supports two Intel Xeon processors over an 800 MHz system bus1 MB L2 up to 3.60 GHzHyper-Threading technologyIntel Extended Memory 64 TechnologyDemand Based Switching with Enhanced Intel SpeedStep TechnologyStreaming SIMD Extensions 3 (SSE3)ChipsetIntel 7520 Memory Controller Hub (MCH)Intel 82801EB I/O Controller Hub 5 (ICH5)Intel 6700PXH 64-bit PCI HubSystem memorySupports dual channel DDR333 memory module8 DIMMs support up to 16GBSupports Registered with ECC memory modulesSupports 128MB/256MB/512MB/1GB/2GB memory modulesGraphics ATi RageXL video controller with 8MB on boardLANDual Broadcom BCM5721 NetXtreme Gigabit Ethernet ControllerServer ManagementSupport IPMI 1.5Support mBMCUSBTwo(2) USB 2.0 ports at the rear panelThree internal connectors for six front panel USB 2.0 portsOn board IDETwo channel Ultra 100/66/33 ATASupport ATAPI IDE CD-ROM, ZIP-100 & LS-120On board SATAAdaptec AIC8140 SATA controller on boardEight SATA II portsSupport Adaptec Host RAID 0, 1, 10Two SATA ports by ICH5Expansion SlotTwo PCI Express x8 (one with x4 bandwidth)One PCI-X 64/133Two PCI-X 64/100PCI 2.3 CompliantPCI-X 1.0 specification compliant Rear Panel I/OPS/2 mouse and keyboard connector1 x VGA port1 x 9-pin 16550-based serial port2 x USB 2.0 ports2 x RJ-45 PortsSystem BIOS AMI BIOSFlash write protection for BIOS and one jumperSupport ACPI S1From Factor E-ATX Form Factor12” x 13"SSI EEB 3.5 CompliantEPS 12V Power SupplyIt is highly recommended to always use the most recent driver version available.Do not forget to check with our site as often as possible in order to stay updated on the latest drivers, software and games.Try to set a system restore point before installing a device driver. This will help if you installed a wrong driver. Problems can arise when your hardware device is too old or not supported any longer.

IWILL DNS-SATA BIOS 110

Mirror 1