License: Freeware
Downloads: 1
Op. System: Windows XP/Vista/7
Last updated: 12-05-2012
File size: 1.08 MB
Publisher: Steinberg Soft und Hardware GmbH, Germany.

Publisher description for CrunchDude

CrunchDude program icon

The Heeb CrunchDude is a very simple, yet effective guitar amplifier emulation VST plug-in. As the name implies, its strength lies not only in clean or over-the-top lead sounds, but especially in the excellent crunch sounds it can produce (certainly a weak point in many similar devices, virtual or otherwise). Its use is not limited to the electric guitar however. It can also be extremely useful in processing e.g. bass guitar, synthesizers, etc. Let your imagination run wild, and let your ears be the judge! Main features: - The Input section. No distortion takes place here yet, only amplification and equalization. Set the Input Gain to a level appropriate for your instrument or track. Low Cut (which determines the cut-off frequency of the 6 dB/octave high-pass filter) should typically be turned to the right (maximum frequency = maximum cut) for electric guitar operation (unless a Low Cut has already been applied). - Two Pre-amp sections. These are switched in series, and completely identical. You can switch them on and off. They have a 3-band equalizer with adjustable cut-off frequencies, and a Drive dial that determines the gain and the resulting distortion. The equalizer is "passive", which means that when Low, Mid, and High are in maximum position, no alteration of the sound takes place (flat frequency response, 0 dB gain). - The Output Stage section. Again, you have the same type of 3-band equalizer at your disposal, an Output level dial (mind the level on the VU-meter in the Cabinets section!), and an extra Low Cut dial, which should typically be in or close to the 12 o'clock position when using the Cabinets section (which boosts low frequencies considerably). - The Cabinets section. It says "Cabinets", because there are two almost identical sections in parallel here, which you can balance with the Mix dial. You can switch this section off (but be honest: would you want to?). The sound of both sections is determined by their Prox (proximity) and Fdb (feedback) dials. Typically, you would have Prox1, Fdb1 and Fdb2 turned all the way to the right, Prox2 somewhere around 12 o'clock position. Mix after taste. NB: in some positions, you can hear a slight high frequency "ringing". This is normal, and deliberate.

Add your review

User reviews