Electric Drive Train Simulator
|Op. System:||Windoows All|
|File size:||2.58 MB|
Publisher description for Electric Drive Train Simulator
This electric-drive-train-development tool is for electric go-carts, electric scooters, electric motorcycles, radio-controlled cars, BattleBots, robots, and other types of electric vehicles. Select motors, batteries, the gear ratio, and wheel size, then take your toy for a test drive on a virtual test track. EDTSim reports torque, pushing force, maximum velocity, RMS current, and other useful information for building an electric vehicle. FEATURES: Excellent design tool for building robotic R/C type drive trains like those used in BattleBots, BattleBots IQ, Robot Fighting League, Robotica, BotBash, First Robotics, Best Robotics or Robot Wars. Includes four wheel car type and cycle type drive trains that can be used in designing electric go-karts, electric scooters or electric motorcycles. Simulates battery voltage, state of charge, and internal resistance, so you can see how your bots performance changes as the batteries run down. Motor simulation allows you to see how motors will run at higher or lower voltages than the motor's designed voltage. Motor manufacturers rate motors in different ways making it difficult to compare motors. In EDTSim all motors are rated in the same way, using the motor constants, making it easy to compare motors. Large database of motors includes size, weight, torque, rpm, manufacturer, approximate price and places to buy them. All motors listed on the Links page are included in the database. Motor and drive train specs can be displayed in whatever metric or imperial units you prefer. Motor performance and drive train acceleration graphs. Large battery database includes size, weight, voltage, internal resistance, Peukert value and capacity at different discharge rates. Knowing a motor's power rating isn't enough. The power you'll get out of a system isn't just dependent on the motor, it depends on the motor, batteries and the electrical resistance of the speed controller and wiring. EDTSim takes all these factors into account and tells you the power of all the components combined. Includes motor and battery editor so you can use manufacturer specs or test data to add motors and batteries to the database. Includes example drive trains ranging is size from 1 to 360 lb and can be used for any size drive train that uses permanent magnet DC (PMDC) electric motors. Includes twelve drive train configurations, two, four and six wheel tank or wheelchair type differential steering (also known as skid steering) drive train types with two, four or six motors. Two and four wheel car type Ackerman steering with front, rear and four wheel drive configurations.